Page: 7/17
3). Hold the unit with one hand and the heat exhaust hose short connector with another
hand; or both people cooperate with one person holding the unit and the other person
pulling the heat exhaust hose to prolong the heat exhaust hose gently.
Note: 1. Do not separate the heat exhaust hose assembly from the unit.
2. Do not tilt the unit when pulling apart the heat exhaust hose.
1.4 Installation of the window sealing board assembly
2). Half open the window and mount the window sealing board assembly onto the window,
either vertically or horizontally (as shown in Figure 7 and 8).
3). Pull apart the parts of the window sealing board assembly, adjust the distance of the
window sealing board assembly pulled apart so that the two ends of the assembly
come into contact with the window frame, and fasten the parts of the assembly with
copper screws.
Figure 8
Figure 7
1.5 Installation of the unit
1). Move the machine with the heat exhaust hose assembly installed before the window
and keep the unit at least 50cm away from the walls or other objects. (As shown in Figure
9).
Figure 9
2). Snap the flat end of the heat exhaust hose short connector into the elliptical hole of
the window sealing board assembly (as shown in Figure 10 and 11).
Note: 1. The flat end of the heat exhaust hose short connector must be snapped into
place.
2. The heat exhaust hose may not be bent and shall be free from significant
(greater than 45°) flexure, and the heat exhaust hose shall be ventilated properly.
Figure 10
Figure 11
