Page: 15/17
Air outlet
Handle position
2. Leave the unit in the upright position when handling or moving it.
3. To handle or move the unit, drain the water in the unit first to prevent the water in
the unit from flowing onto the ground or carpet.
4. If the remote control is in the position of the handle, take out the remote control.
Figure 16
End of Season Storage
1. Screw off the drain cap, unplug the water plug and drain the water in the water tray to
another vessel that holds water.
Note: the tilt angle of the unit shall not be greater than 30 degrees.
2. Start the unit, turn the mode to the low fan speed state of the air supply mode, keep this
state for half a day and dry the interior of the unit to prevent mold.
3.
Turn off the unit, unplug the power plug, wrap the power cord around the wire-winding
post, insert the plug into the universal jack at the back shell of the unit; install the water
plug and drain cap.
4. Remove the heat exhaust hose assembly and keep it properly.
Note: to remove the heat exhaust hose assembly, hold the handle of the C shape buckle
of the heat exhaust hose by hand, pull the C shape buckle outward evenly, rotate the C shape
buckle of the heat exhaust hose clockwise once the buckle is separated from the snap
position of the C shape buckle of the back shell and then take out the heat exhaust hose
assembly.
5. Pack the air-conditioner properly with soft plastic bag, put the unit in a dry place & take
appropriate dust-proof measures, and keep the unit out of the reach of children.
6. Take out the batteries of the remote control and keep it properly.
Note: ensure that the unit is put in a dry place. All accessories of the unit shall be protected
properly.
