3
1
2
Name of Each Part
Sip Area
Stopper
Cover
Button
Safety
Lock
Lid Cover
Mouth
Main
Body
Stopper
Lid Set
Stopper Cover Set
The Gaskets are
not removable.
Gasket
Vacuum Layer
Sticker
Drink Level
Beverage
A
Inside of the Main Body
Leave a bit of space below
the rim (part A).
WARNING
CAUTION
Household Use Only
I
mportant Safeguards
●
Please read these instructions before use, and keep for future reference.
●
The illustrations used in this instruction manual may differ from the actual
product you have purchased.
Note: The rattling noise that may be heard when the Main Body is shaken comes
from the metallic foil used in the vacuum insulation to increase heat (cold)
retention, and does not indicate a malfunction.
STAINLESS MUG
Instruction Manual
SM-WS
Model
SM-V
Do not allow infants or small children to use this product. Keep out of the
reach of infants and small children.
Be sure to follow the instructions.
These WARNINGS and CAUTIONS are intended to prevent property damage or
personal injury to you and others.
■
The degree of danger or damage by the misuse of the product is indicated as follows:
Indicates risk of injury
or property damage if
mishandled.
Indicates risk of serious
injury or death.
WARNING
CAUTION
■
Prohibited or required actions are indicated as follows:
Indicates a prohibited operation.
Indicates a requirement or instruction
that must be followed.
*The illustrations are of the SM-WS model.
When containing hot beverages:
●Do not open the Lid Cover
with the product close to
your face or tilted toward
you, as this may cause
the beverage to spurt out
and scald you.
●Be careful, as it may cause scalding.
●Drink slowly without tilting the product
suddenly.
●When pouring hot beverages into the
Main Body, be careful not to let it tip
over.
Do not attach parts other than those
specifically designed for this product.
Do not disassemble the product
(other than parts designed to be
disassembled).
Do not use the product if its thermal
insulation performance has
deteriorated.
Do not use if water enters
the Vacuum Layer.
Drinking the water that
seeps out from the Vacuum
Layer may cause illness.
Do not fill the product with the Lid Set
attached, as it may overflow.
Do not hold the product by the Lid Set
when carrying, as the product may fall
and cause injuries.
Do not use this product for other
than storing and keeping beverages
hot or cold.
This product is designed to be drunk
directly, so the beverage may splash
if it is used for pouring.
Do not place near heat sources such
as gas stoves, ovens, and heaters, as
doing so may cause burns or product
malfunction.
Do not heat in a microwave, as doing
so may cause sparks.
Do not place near open flames (from
gas stoves, etc.), on top of electric
heaters, or IH cooking devices, as
doing so may cause a fire or
malfunction.
Avoid dropping or hitting against
hard surfaces.
Do not drink out of the product while
driving.
Never fill the product with the
following:
● Dry ice or carbonated drinks
●
Liquids high in sodium such as soup or
Kobu-cha
● Dairy products or fruit juice
● Fruit pulp or tea leaves
Do not scratch or rub the design on
the outside of the Main Body
strongly using fingernails or hard
objects, as this may cause the
design to come off.
Do not remove the
sticker on the bottom
of the Main Body.
Fill the Main Body
only up to the level
shown in the
illustration.
Always make sure that the parts are
attached during use.
Make sure that there is no beverage
leakage before using the product.
When using a vehicle drink holder:
●Make sure that the product sits
securely inside the drink holder.
Consume beverages within the same
day.
Leaving beverages for a long time may
cause them to spoil. This may also
cause the beverage to come out, or the
Lid Set to burst.
Thoroughly clean the inside and
Mouth of the Main Body, and the Lid
Set after every use. Be particularly
careful after filling the product with
sports drinks.
After adding hot beverages, the
pressure inside the product may rise,
making it difficult to remove the Lid
Set. If that happens, open the Lid
Cover once, then remove the Lid Set.
If the Lid Cover is left closed for an
extended period, the pressure inside
the product may decrease and make it
difficult to open the Lid Cover. If this
occurs, detach the Lid Set to open it.
Break ice cubes into smaller pieces,
as failure to do so may cause
deformation of the Main Body and
leakage.
Place the product vertically when
carrying it in a bag to prevent
leakage or condensation.
Do not shake the product.
