ZOJE ZJ2842-BD, Operation Manual

Page: 34 / 76

21
1. Raise the needles to the highest positions,and
open the slide plates by moving them to the right
and left.
2. Pull the rotary hook latches upward,and then
remove the bobbin .
1. Raise the needles to the highest positions,and
open the slide plates by moving them to the right
and left.
2. Pull the rotary hook latches upward,and then
remove the bobbin .
1. Raise the needle to this highest positions,
and open the slide plates by moving them to
the right and left.
2. After lifting up the rotary hook latch ,life the
corner of the cap to moving the cap .
1. Raise the needle to this highest positions,
and open the slide plates by moving them to
the right and left.
2. After lifting up the rotary hook latch ,life the
corner of the cap to moving the cap .
1. Turn on the power switch.
2. Place the bobbin
onto the bobbin winder shaft .
3. Wind the thread several times around the bobbin in
the dirction indicated by the arrow.
4. Push down the bobbin presser arm .
5. Raise the presser foot with presser lifter.
6. Depress the treadle.Lower thread winding will then start.
7. Once winding of the lower thread is completed,the bobbin
presser arm will return automatically.
* If the thread cannot be wound on evenly, loosen the screw
and move the bobbin winder guide to the side where
there is less thread.
* Turn the adjustment screw to adjust the bobbin winding
amount.
To increase the winding amount:Tighten the screw.
To decrease the winding amount:Loosen the screw.
Note: The amount of thread wound onto the bobbin should
be a maximum of 80% of the bobbin capacity.
1. Turn on the power switch.
2. Place the bobbin
onto the bobbin winder shaft .
3. Wind the thread several times around the bobbin in
the dirction indicated by the arrow.
4. Push down the bobbin presser arm .
5. Raise the presser foot with presser lifter.
6. Depress the treadle.Lower thread winding will then start.
7. Once winding of the lower thread is completed,the bobbin
presser arm will return automatically.
* If the thread cannot be wound on evenly, loosen the screw
and move the bobbin winder guide to the side where
there is less thread.
* Turn the adjustment screw to adjust the bobbin winding
amount.
To increase the winding amount:Tighten the screw.
To decrease the winding amount:Loosen the screw.
Note: The amount of thread wound onto the bobbin should
be a maximum of 80% of the bobbin capacity.