ZOJE ZJ-M3-S500-SF-V2, Manual

Page: 154 / 190

Template machine - Touch screen E2
Setting
58
U5-5 Delay in laser cutting section 1 1-30000 1
U5-6 Laser cutting first delay 1 1-30000 1
U5-7 Laser cutting total power hold time 0 0-100 1
U5-8 Whether the head of the laser section is raised
or not
ON ： allow OFF ： forbid
ON ： allow
U5-9 Lift cylinder origin signal detection enable
ON ： Open OFF ： Closed
ON ： Open
U5-10 Frequency of abnormal protection of laser
cutter communication
1 1-10 1
U6 Moving frame speed and timing
No.
Description
Default Value
Range Step
size/unit
U6-1 Empty speed gear 2 0-9 1
U6-2 Sew the end back to the original speed gear 2 0-9 1
U6-3 Try sewing speed gear 50 1-100 1
U6-4 X axis seam - up frame Angle fine adjustment 0 -120-120 1
U6-5 Y axis from the seam frame Angle fine
adjustment
0 -120-120 1
U6-6 X axis moving frame Angle fine adjustment 0 -120-120 1
U6-7 Y axis moving frame Angle fine adjustment 0 -120-120 1
U6-8 X axis moving frame time adjustment 0 -100-100 1
U6-9 Y axis moving frame time adjustment 0 -100-100 1
U7 Head and tail reinforcement and breakage detection
No.
Description
Default Value
Range Step
size/unit
U7-1 The number of starting
stitches
0 0-2 1
U7-2 Initial pin reinforcement
mode setting
2: reinforce the first
few stitches 0: not reinforced
1: reinforce in the
first
stitch
2: reinforce the first
few
stitches
3: zigzag seam
reinforcement
U7-3 Number of stitch
reinforcement
-2 -4-4 1
U7-4 End pin reinforcement mode3: end N type0: not reinforced