Zodiac Z300 Series, Instructions For Installation And Use Manual

Page: 19 / 96

H0439100.C - EN - 2015-01 6
EN
• Remote on/off control
- Function: connect a remote «on/off» button
- Thanks to a zero-potential free contact, without 230 V - 50 Hz polarity, connect the cable to the busbar between
terminals 7-8,
- Activate the command by pressing for 5 seconds when regulation is not on standby: then
, then press 3 seconds on : , select «Yes» using key , then validate by
pressing : , press to exit.
A1-A2 : supply to the power contactor coil of the filter pump
B : filter timer
C : power contactor (3-pole or 2-pole), supplying the filter pump
D : independent connecting cable for the «heating priority» function
E : terminal
F : fuse
G : independent connecting cable for alarm contact relay
H : alarm contact relay
I : remote on/off switch
J : independent connecting cable for remote on/off control
• Remote control unit
- Function: control the heat pump remotely.
- Refer to the instructions for the remote control unit for connections.
3. Use
3.1 Presentation of the regulation
Cold mode
(only on reversible models)
Water temperature
Setpoint temperature
Symbol Designation steady flashing
Water flow Water flow-rate ok Water flow too weak, high or absent
Ambient air temperature Adequate Inadequate
Operation indicator
During heating or air
conditioning
On standby until operating command
received
Defrost indicator Defrost in progress /
On/off button
button to set and confirm parameters
value setting buttons