H0491600.B EN - 2014/11
12
EN
8.3 Meanings of the LED FLASHES and the error codes
PROBLEMS
SOLUTIONS
OV 3300 - OV 3400 - RV 4310 -
RV 4400 - RV 4460
OV 3500 - RV 4550
RV 5400 - RV 5470
RV 5500
10
•
Check that the cleaner is correctly connected to
the control box. If necessary, unplug it and recon-
nect it following the appropriate procedure.
2, 3, 5 and 6
•
Check that nothing is stopping the brushes and
tracks from turning correctly (sand, cable, etc.). To
do so, raise the tracks to check that there are no
external elements jammed in a housing.
7 and 8
• Cleaner operating outside the pool. Make sure
you start the cleaner when it is in the water (see
§ 1.5).
1 and 4
•
Check for the presence of pebbles or hair in the
fan, if necessary clean the filter.
If the problem continues contact your reseller.
8.4 Other possible situations
PROBLEMS
SOLUTIONS
The screen displays the
message
when the remote control mode is active
(OV 3500 - RV 4550 - RV 5500)
• This means that the remote control batteries are too low.
The remote control LED is flashing or the
LED is on steady (OV 3500 - RV 4550 -
RV 5500): Remote control range problem
•
Make sure the control box is placed on the caddy at least 3.5 metres
from the pool.
•
Orient the control box towards the pool in order to improve the range of
the remote control. Make sure there are no large objects between the
control box and the pool.
The remote control LED is on steady
(OV 3500 - RV 4550 - RV 5500):
Synchronisation problem
• Repeat the synchronisation steps (see § 6.5).
The cleaner does not stay firmly on the
pool bottom
This may have 3 causes:
• There is still air in the casing of the appliance. Repeat the immersion
operations (see § 1.5).
• The filter is full or dirty: clean the filter.
•
The propeller is damaged: contact your reseller
The cleaner does not or no longer climbs
the pool sides
This may have two causes:
• The filter is full or dirty: clean the filter.
• Even though the water seems clear, microscopic algae are present in
your pool, they are not visible to the naked eye, and they make the sides
slippery and prevent the cleaner from climbing. Carry out shock chlorina-
tion and slightly reduce the pH.
Do not leave the cleaner in the water during shock treatment.
The cleaner does not perform any move
-
ments on start-up.
• Check that the outlet to which the control box is connected is receiving
a power supply.
• Check that you have started a cleaning cycle and check that the indica
-
tors are on.
If the problem continues contact your reseller.
The cable gets tangled
• Do not unroll the entire length of the cable into the pool.
• Place the required length of cable in the pool and place the remainder
on the side of the pool.
The control unit does not respond when
you press the buttons
• Unplug the cable from the mains socket, wait 10 seconds and plug it
back in again.
If the problem continues contact your reseller.
