H0491600.B EN - 2014/11
10
EN
6.3 Taking the cleaner out of the water (
RV 4550 - RV 5500)
•
Press the
button quickly. The
message is displayed.
•
The cleaner moves toward the wall and climbs up to the waterline.
6.4 Switching off the remote control
•
Press
.
The remote control is switched off but the cleaner continues to operate.
6.5 Synchronise the remote control with the control box (in the event of a change of remote / control box,
or both)
If equipment is replaced, it is essential to synchronise the remote with the control box.
•
Place the remote control
about 50 cm away
from the control box.
• Connect the control box, check that the display shows the operating time, and that no cleaning cycle is running.
•
Switch on the remote control by pressing
.
•
Before the remote control puts on hold (around 45 seconds) press the
and
buttons simultaneously for 6 seconds.
• Check that synchronisation was successful by observing the display and the remote LED:
Display on the
control box
Remote LED
Result
Good
2 seconds
Remaining cycle time
0:45
The LED starts to
flash
• Synchronisation successful.
FAIL
The LED is not
flashing
•
Check the distance between the control box and the remote
control is around 50 cm.
• Check remote control batteries. Change them if necessary.
• If the problem continues contact your reseller.
7. Maintenance
7.1 Cleaning the filter
The cleaner performance can be reduced if the filter is full or dirty. Make sure you clean the filter regularly
with clean water for efficient pool cleaning.
Filter access
"Filter cleaning" indicator
(RV 4400 - RV 4460 - RV 4550 - RV 5400 - RV 5470 - RV 5500)
If the indicator on the control box lights up, it is strongly recommended
to clean the filter to optimise cleaning performance.
Replace the filter support every 2 years to preserve
the integrity of the cleaner and guarantee optimum performance.
7.2 Replacing the brushes
• The cleaner is fitted with PVC brushes. They have wear indicators (1).
• To remove worn brushes, remove the tabs from the holes in which they are fixed.
• To fit new brushes, start by fitting the side without tabs under the brush holder (2).
