17
CONNECTING TO A CONTROLLER
TESTING THE WIRING CONNECTION
Once a connection has been made between the Controller and the Chlorine
generator, it will need to be tested.
1. Turn on the power to the Controller and the Zodiac TRi.-XO
2. If successful, a ‘ ’ symbol will appear in the top right hand corner of the screen
after about 20 seconds.
3. If the controller does not connect, turn power off to both the devices and try
again.
VERIFY THE WIRING CONNECTIONS
To verify the connection:
1. Switch the TRi-XO unit on and check the controller setting (follow instructions
under ‘SETTING CONTROLLER’).
2. Re-test the connection.
Note:
For safety reasons, the Zodiac TRi-XO reverts to the OFF setting if the
communication connection is lost.
CONNECTION TO CONTROLLER FOR POOL/SPA COMBINATIONS
• To connect a Zodiac TRi-XO unit to Pool or Spa Valves, you will need to make
a “splice” into the control lines from the Controller, located inside the controller
itself.
• For further information, consult the installation manual of the Controller being
used.
CONNECTING TO A CONTROLLER
