15
97206
DECEMBER 2, 2003 (Round Pool - 1" Rims)
Your 9" x 11" NO DIVING sign must be posted in plain sight near your pool entry/exit location to remind pool users
of the importance of this safety information.
If you are not installing a fence or a deck on which to post your sign, you may attach it to the pool top ledge (FIG.
24). Drill 1/8" diameter holes in the outside of the top ledge (adjacent to the entry/exit location) and fasten sign with
the enclosed attachment wires.
TOP LEDGE
WITH DECAL
TOP LEDGE
WITH DECAL
LINER NO DIVING DECAL
INSTALL LINER NO DIVING
DECALS HERE
DESIGNATED
POOL ENTRY
AND EXIT
INSTALL NO DIVING
SIGN ADJACENT TO
POOL ENTRY/EXIT
When pool is filled with water to correct skimmer level, install the two NO DIVING warning decals which you set
aside in STEP 6.
a. Apply decals to the liner just above the maximum water level and just below the top ledge.
b. Install one decal at the entry/exit location. Install second decal directly across the pool from the entry/exit location (FIG. 24).
NO DIVING warning decals have been factory applied to four top ledges (FIG. 21). Install one of these ledges at
the entry/exit of your pool; install the second ledge directly across the pool from the entry/exit location (FIG.23).
Install remaining two top ledges with decals at 90° to entry/exit as shown in FIG. 24.
8' & 12' POOLS:
Fasten each top ledge (FIG. 19) to top plates with four #10 x 1/2" sheet metal screws as shown in FIG.
22. Use
slots in ledges as necessary.
15' THRU 27' POOLS:
a. Top ledges are numbered on each end to correspond to the pool diameter (FIG.19).
Use the numbered slots that
correspond to your pool diameter. Note:
27' pools use slots numbered 24.
b. Fasten each top ledge with four #10 x 1/2" sheet metal screws as shown (FIG.
24). If uprights lean in or out when pool
is filled with water, adjust several top ledges by moving them to the next slot.
Step 10.
INSTALL T OP LEDGE
Step 11.
INSTALL NO DIVING DECALS
Step 12.
INSTALL NO DIVING SIGN
FIG. 24
