2
in the vicinity of the moving parts during operation of the appliance. Moving parts
can cause serious injury or even death.
WARNINGS ASSOCIATED WITH ELECTRICAL APPLIANCES
•
The electrical supply to the appliance must be protected by a 30 mA differential
Residual Current protection Device (RCD), complying with the standards and
regulations in force in the country in which it is installed.
•
Do not use any extension lead when connecting the appliance; connect the
appliance directly to a suitable power supply circuit.
•
If a stationary appliance is not fitted with a supply cord and a plug, or with other
means for disconnection from the supply mains having a contact separation in all
poles that provide full disconnection under overvoltage category III conditions, the
instructions shall state that means for disconnection must be incorporated in the
fixed wiring in accordance with the wiring rules.
•
A Suitable disconnecting means, which complies with all local and national
requirements for over-voltage category III, and which disconnects all poles of
the supply circuit, must be installed in the supply circuit to the appliance. Such
disconnecting means is not provided with the appliance and must be provided by
the installation professional.
•
Before carrying out any operations, check that:
-
The voltage indicated on the appliance information plate corresponds to the
mains voltage.
-The power grid is adapted to the power requirements of the appliance, and is
grounded.
-
The plug (where applicable) is suitable for the socket.
•
In the event of anormal operation or the release of unusual odours from the
appliance, turn it off immediately, unplug it from its power supply and contact a
professional.
• Before any access to the appliance for service or maintenance, ensure that it is
switched off and completely disconnected from the power supply. Furthermore, in
addition to confirming that the heating priority (where applicable) is deactivated,
ensure that any other equipment or accessories connected to the appliance are
also disconnected from the power supply circuit.
• Do not disconnect and reconnect the appliance to the power supply when in
operation.
• Do not pull on the power cord to disconnect it from the power supply.
• If the power cord is damaged, it must be replaced by the manufacturer, its technician
or a qualified person to guarantee safety.
•
Do not perform maintenance or servicing operations on the appliance with wet
hands or if the appliance is wet.
•
Before connecting the appliance to the source of supply, ensure that the terminal
block or supply socket to which the appliance will be connected is in good condition
and is not damaged or corroded in any way.
•
For any component or sub-assembly containing a battery: do not recharge or
dismantle the battery, or throw it into a fire. Do not expose it to high temperatures
or direct sunlight.
• In stormy weather, disconnect the appliance from the power supply to prevent it
from suffering lightning damage.
•
Do not immerse the appliance in water (with the exception of cleaners) or mud.
WARNINGS CONCERNING APPLIANCES CONTAINING R32 REFRIGERANT
• This device contains R32 refrigerant, a class A2L refrigerant, which is considered to
be potentially flammable.
•
Do not discharge R32 fluid into the atmosphere. These are fluorinated greenhouse
effect gases, covered by the Kyoto Protocol, with a Global Warming Potential (GWP)
= 675 (EU Regulation No. 517/2014).
•
In order to comply with relevant environmental and installations standards and
regulations such as, but not limited to, French decree No. 2015-1790 and/or the EU
Regulation EU 517/2014, the cooling circuit must be checked for leakage at least
once a year. This operation must be carried out by a certified cooling appliance
specialist.