The or indicator shows the current mode (auto or manual).
In manual mode, pressing the or buttons causes the robot
to advance or reverse until the central button, or the opposite
direction’s button, is pressed. When you press or button,
the robot turns in the corresponding direction. As soon as you release the
button, the robot continues in a straight line.
Programmes
These 24 programmes are designed for the optimal performance of your robot.
They enable you to choose the parameters that are best suited to the dimen-
sions and the shape of your pool. You should choose one of these programmes
according to the width and the shape of your pool.
To activate one of these programmes, refer to chapter. Programming the
robot, on page 15.
The programmes in the robot’s memory are:
Microprocesssor
The Lazernaut™ is controlled by a microprocessor to ensure optimal cleaning in all
pool configurations. This microprocessor also offers the following functions.
Poolside system:
In the event that your Lazernaut™ comes out of the pool onto a poolside
surface, the microprocessor is able to detect the lack of water. The robot turns
around and goes back into the pool to continue cleaning.
Out-of-water security system:
If the Lazernaut™ does not succeed in going back into the water,
or if the robot is started out of the water, the microprocessor shuts off
the robot’s power supply after approximately 20 seconds to avoid damage to
the waterproof joints.
16
Program
numero
0
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
Maximum
width of
the pool
3
4
5
6
7
8
3
4
5
6
7
8
3
4
5
6
7
8
3
4
5
6
7
8
Shape of
the pool
Test program
Rectangular pool
with flat bottom
or complex slope
Rectangular pool
with pyramid
shaped diving
area
A circular
shaped pool
An oval shaped
pool
