Zodiac INDIGO, Manual

Page: 14 / 30

14
2.8.2. Track Guide Roller Track
Replace the old part with a new one and place the complete plate on the housing.
Make sure you fit the roller in the right direction.
2.8.3. Track Plate
Remove all the parts of the old plate. The carefully take out the brass spindle with pliers, making sure
you don't make any scratches.
With a small hammer, fit the new brass spindle to the new plate.
Fit all the moving parts to the plate.
Assemble the complete plate on the housing.
2.8.4. Plate Assembly (cable side) on the Housing
All the parts can be assembled on the track plate. You will need to turn the unit over.
a) Start by placing the top of the plate (handle side). Then fit the track plate on to the housing.
b) Fit the 3.9 X 25 self-tapping screw and its washer.
c) Place the brush holder spindle into the track plate, and then the other one.
d) Insert the other two 3.9x25 screws and their washers.
e) Fit the track on to the brush holders.
f) Turn the unit over and insert the screw belonging to the top of the plate.
a c e
Fit the handle (lowest float on the cable side) , the motor unit protective screen and the bumpers to
complete the assembly of the robot.
2.9. M
OTOR
U
NIT
To remove the motor unit you will need to take out the bumpers, the handle, the motor unit protective
screen, the plate opposite the cable and then the plate on the cable side.
Important: do not open the motor unit during the guarantee period.