XPLC300 Motion Controller Hardware Manual V1.5
Max current
-6mA (negative)
Isolation mode
optoelectronic isolation
Note: the above parameters are standard values when the voltage of controller power
supply (E+24V port) is 24V.
→
Wiring Reference
→
Wiring Note:
⚫
The wiring principle of high-speed digital input IN (0) is shown in the figure above.
The external signal source can be an optocoupler, a key switch or a sensor, etc., all
can be connected as long as the requirements on output of electric level can be
achieved.
⚫
For the public end, please connect the "EGND" port on the power supply to the "COM"
terminal of the external input device. If the signal area power supply of the external
device and the power supply of the controller are in the same power supply system,
this connection also can be omitted.
⚫
When routing terminal wiring cables, avoid bundling them with cables with strong
interference signals such as power lines, and must route them separately.
Summary of Contents for XPLC300
Page 1: ......
