Product Manual - ZMORPH i500
47
Maintenance
10.7 Removing a printout from the platform
After finished work machine will park the extruder and heated bed in safe position.
Wait until the temperature of the table drops before removing the printout from the table. This will allow
you to remove the printouts without damaging them.
If the printout could not be removed despite the low temperature of the table, gently lift the printout
with a spatula.
To be able to print models with more complex geometry, additional support is printed, which is not a
part of the model. When the printout is complete, remove them carefully. Pliers are best suited for this
purpose. In case of problems with removing the support, you can use a knife to help you.
Some of the models can be printed with soluble supports, like BVOH, PVA or HIPS. For those prints
instead of removing supports mechanically put the print into required liquid, you can an ultrasonic
washer as well. To check in which liquid our support will dissolve refer to the materials library
zmorph3d.com/product/materials
The spatula has sharp edges that may cause the table to be scratched. When taking off the printout, lay
it as parallel as possible to the table and be careful.
Use safety goggles when removing the support
material, small pieces may suddenly brake and
scratch your eyes.
NOTE
NOTE
10.8 Support material removal
