24
Rudder mounted over pushrod hole.
Trim tabs mounted on your marks.
Turn fin on right. You can add one to the left as well.
Drill this hole in the transom with a ¼ inch bit.
You can enlarge this later if needed.
Assemble the rudder to the brackets.
Mount the rudder to the transom over the
pushrod hole, aligning the rudder blade to your
reference line, 2-1/2 inches to the right of
center.
Try to get the pushrod hole centered in the
rudder access hole.
Trim Tabs
Mount your trim tabs to the transom so that they
are flush or just a hair up from the bottom. No
more than 1/16 inch above the bottom
Also mount them so that they start 1-1/2 inches
from the center of the hull, on your marks.
Turn fin
The turn fin should be mounted on the extreme
right side of the transom, above the trim tabs.
Make sure the fin is 90 degrees to the bottom. It
will be canted outward with the hull level.
The turn fin should extend to the keel, with the boat
sitting level on the table.
Summary of Contents for VBox 2013 Edition Deep Vee Sport Crackerbox
Page 6: ...6...
