22
Glass cloth in place.
Fiberglass on center seam.
Lines are parallel. Camera makes them look otherwise.
Fiberglassing
Seam
Use the supplied 6 ounce cloth,
The cloth is pre cut into two pieces, one from
the back of bulkhead 3 to 4, and one from 4 to
5.
Mix more finishing resin.
Brush resin onto the center seam and lay the
cloth down, centered on the seam.
The cloth goes between bulkheads 3 and 4,
then another piece between 4 and the transom.
This cloth reinforces the center seam area and
must not be left out.
Brush in a coat of resin, so that the cloth is
completely wetted.
Continue coating the inside with finishing resin.
If you need to mix more, use a new container
and brush. If you don’t, the old resin will mess
with the new resin, and create a problem. Trust
me…
If you have any excess resin, go ahead and
start coating the inside of the hull.
Hardware
Now is a good time to install all of the hardware,
as well as the engine, shaft tube and radio.
Without the top deck in place, everything is easy
to get to.
Draw a line on the transom, from top corner to
top corner.
Draw a line from the center of this line to the
bottom of the boat at the vee.
This is the center of the transom.
Summary of Contents for VBox 2013 Edition Deep Vee Sport Crackerbox
Page 6: ...6...
