![background image](http://html1.mh-extra.com/html/zippkits/g30/g30_manual_3806551008.webp)
8
Fuselage
As you remove parts from the sheet, sand off the little
bumps left by the holding tabs. They can interfere with
the fit in some cases.
Build the fuselage flat on your building board.
Use waxed paper to prevent the fuselage from sticking to
the bench.
We used medium CA glue for the entire fuselage.
You can also use Titebond or similar.
Glue bulkhead 4 to the tunnel floor. Glue bulkhead 5B,
then 5C to the floor.
Use a square on these bulkheads.
Be sure that 5C is perfectly aligned with 5B
Glue the two 1/8 sides to the 1/16 floor.
Use a square to make sure that the sides are 90 degrees to
the bench.
Be sure that the notches are fully seated in the bulkheads
you glued, as well as in the floor.
Add bulkheads 1 thru 3, locking them into the sides.
Both bulkhead 3 parts should have the number facing out
as shown.
Summary of Contents for G30
Page 1: ...1 G30 Outboard Tunnel Hull For 21 Nitro or 4S electric Length 30 5 inches Beam 11 5 inches...
Page 24: ...24...
Page 25: ...25...