![background image](http://html1.mh-extra.com/html/zippkits/g30/g30_manual_3806551007.webp)
7
Glue the sponson rear cap in place, sitting on the bottom
sheet. Tape in place.
When cured, sand flush with top and sides.
Be sure to leave the overhang on the bottom only.
Glue the top in place. Leave an even overhang all around.
Tape tightly until cured.
Repeat on the other side.
Once cured, sand all sides flush.
Be sure to leave the
rear overhang
.
All sheeting should be sanded flush, except the bottom. It
will have a 1/16 inch overhang when completed.
Sand the nose flat and flush with all sheeting.
Glue the pine nose block in place.
When cured, bevel and shape for desired look.
Repeat for the other sponson if you have not already done
so.
Trim any excess and sand with 220 on a block. The
sponsons are now ready for sealing.
You can round the corners on the outside of the sponson,
but leave the inside edges sharp.
You can give them a quick swipe with sandpaper to
lightly knock off the sharp edge, but don’t round them.
The rear overhang should be sharp, and not rounded in
any way.
Basically, any place that touches the water should have a
sharp edge.
Summary of Contents for G30
Page 1: ...1 G30 Outboard Tunnel Hull For 21 Nitro or 4S electric Length 30 5 inches Beam 11 5 inches...
Page 24: ...24...
Page 25: ...25...