12
Get under the F6-F9 pieces and inside the holes in the
bulkheads.
Coat the inside of the radio box and center section.
Only coat the inside now.
Don’t do the outside of anything yet.
Work quickly if the temperature is above 70.
Don’t forget to seal the radio box top and lid.
Coat one side of each cross grain deck piece.
Once you have a good coat of epoxy on the inside, wipe
off everything.
Wipe off as much epoxy from the surface as you can.
Wipe off any sealer from the top of the fuselage and the
radio box.
Wipe off any sealer in the “lip” that the radio box lid sits
in. Wipe it off…
Be really thorough, as any epoxy left here will interfere
with the fit of the tops, and you will have to carefully file
and sand them to fit.
Easier to wipe off that epoxy now.
Wipe off so that the surface is no longer glossy.
Use a Q-tip to get into the recesses if needed.
Allow to cure overnight.
Scrape the sealer on the decks with a utility knife blade,
or sand with 120 grit.
Repeat the exact same procedure for the second coat.
Wipe off areas the get glued (top of fuselage and radio
box, radio box top and lid).
Don’t wipe off the second coat of epoxy on the deck this
time.
When cured, scrape and sand the top deck framework in
preparation for the 1/16 cross grain decks.
If you wiped these areas earlier, you won’t have much
prep to do.
Glue the balsa fuselage nose in place against the front of
bulkhead 1.
The balsa should be a little taller than the bulkhead.
Leave the balsa unsanded for now.
Summary of Contents for G30
Page 1: ...1 G30 Outboard Tunnel Hull For 21 Nitro or 4S electric Length 30 5 inches Beam 11 5 inches...
Page 24: ...24...
Page 25: ...25...