![background image](http://html1.mh-extra.com/html/zippkits/g30/g30_manual_3806551014.webp)
14
Be sure to coat the entire face of the fuselage side with
epoxy.
Get epoxy on all three dowels.
Wipe away excess epoxy.
Do not allow any epoxy into the slots on the sponson
inside.
We used masking tape over them.
We wiped all traces of epoxy from the area, and removed
the protective tape before the epoxy cured.
Tightly clamp in place and allow to cure, wiping away
excess epoxy as you go.
When cured, glue the other sponson in place the same
way.
If the sponson fit isn’t perfect, clamp the front and leave
any gap at the rear.
Fill the gap at the rear (after curing).
Do it this way so that if the sponsons are not parallel with
each other, they have toe in.
Toe in=okay. Toe out=bad.
Anti-Stumble blocks:
Glue the 1/8 stumble block outsides into the tunnel floor
as shown.
Use a square to make them 90 degrees to the floor.
Summary of Contents for G30
Page 1: ...1 G30 Outboard Tunnel Hull For 21 Nitro or 4S electric Length 30 5 inches Beam 11 5 inches...
Page 24: ...24...
Page 25: ...25...