TROUBLE SHOOTING
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
26
ZI-GRM400 | ZI-GRM1100
14.1
Maintenance plan
After each workshift:
Clean the machine as follows:
Run the plucker for two minutes with the irrigation ring on. This will flush most of the feathers on the
plate and in the feather pan out of the unit through the feather chute. Disassemble tub from feather
pan. Remove feathers and debris.
Never grip into the running drum or keep cleaning tools in the running drum!
14.2
Cleaning
N O T I C E
The usage of certain solutions containing ingredients damaging metal
surfaces as well as the use of scrubbing agents will damage the machine
surface!
Clean the machine surface with a wet cloth soaked in a mild solution
14.3
Disposal
Do not dispose the machine in residual waste. Contact your local authorities for information
regarding the available disposal options. When you buy at your local dealer for a
replacement unit, the latter is obliged to exchange your old.
15
TROUBLE SHOOTING
BEFORE YOU START WORKING FOR THE ELIMINATION OF DEFECTS, DISCONNECT THE
MACHINE FROM THE POWER SUPPLY.
Trouble
Possible cause
Solution
Machine will not start
Switch defective
Repair switch
Power supply is off
Repair power supply
Fuse is defective
Change fuse
Electric contactor is defective
Repair or change electric contactor
Safety switch is off
Be sure magnet in tub is poitioned
over magnetic readswtich on feather
pan.
NOTE: Magnet must be adjusted
close enough to safety switch in
order to function properly
.
MANY POTENTIAL SOURCES OF ERROR CAN BE CLEARED BY THE EXPERTLY CONNECTION
TO THE ELECTRICITY GRID.
N O T I C E
Should you in necessary repairs not able to properly to perform or you have
not the prescribed training for it always attract a workshop to fix the problem.
A T T E N T I O N
Should you return the plucker for various reasons, the machine must be
thoroughly cleaned beforehand. If there are still poultry residues in the
machine, the machine can not accepted!