22
Rudder servo in place. Transom block not used with Z strut.
Throttle servo ready to glue to tub.
Throttle servo mounted in tub. Make sure it’s on the correct side…
Bolt the throttle servo to its mount using two
servo screws. Be sure to drill pilot holes so
that the mount doesn’t split.
Glue these to the tub.
Be sure that the servo is on the correct side
for the engine you are using.
We like to use a nylon clevis on the throttle
end, and an EZ connector on the servo end
of the throttle. You may need to use a small
set screw instead of the screw that comes
with the EZ connector to make it fit under
the lid.
