20
Mark on transom. Old style strut shown.
Rudder servo tray parts. Sides are ¼ ply.
Servo tray assembled. Make sure you match servo length.
Assemble the rudder servo tray. This is
made from the servo mount base, strap and
the two 5/8x7x8 inch plywood blocks.
Check the length of your servo, and glue
the blocks in place.
This tray will fit the Hitec HS-225MG servo.
Use epoxy or medium CA to build the tray.
Check the fit of the servo in the tray. You
will have to cut a recess for the servo wire
in one block.
Make sure that the servo is a tiny bit taller
that the mount, otherwise, the strap won’t
tighten the servo.
Use two servo screws (not supplied) to
attach the strap.
