Page 6 of 28
802149UK Celsius residential - Installation instructions -Jan 2016 v2.03
Important safety instructions
This manual contains important safety and installation instructions for the Zip HydroTap
®
G4.
Please read all warnings, installation requirements and installation instructions before
installing any Zip HydroTap
®
G4. This model must be installed in accordance with water supply
byelaws, current IEE regulations and relevant local authority bylaws.
Safety
This HydroTap
®
G4 is not intended for use by children under 8 years old or persons (including children) with
reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have
been given supervision or instruction concerning use of the HydroTap
®
G4 by a person responsible for their
safety. Children should be supervised to ensure that they do not play with the appliance. Cleaning and user
maintenance shall not be made by children without supervision.
Refrigerant
The Command-Centre
TM
contains R134A refrigerant under pressure. Maintenance of the refrigeration unit
must be carried out by an accredited service provider or qualified refrigeration technician.
Qualifications
If the power cable is damaged it must be repaired only by a qualified technician. To avoid hazards, all
installation procedures must be carried out by a suitably qualified trades-person. The power cable and power
outlet must be in a safe visible position for connection.
Venting
Sometimes steam and / or boiling water may discharge through a vent outlet at the tap. If the tap is not
installed using the font pedestal, ensure the tap body is located so the tap outlet safely dispenses into the
sink bowl area.
Lifting
Take care when lifting the Command-Centre
TM
which may exceed safe lifting limits. If you feel this is beyond
your personal capabilities, please seek assistance with the lift. The weight of the Command-Centre
TM
is
marked on the packaging. Do not lift the Command-Centre
TM
by the front cover or any connections at the top
rear of the Command-Centre
TM
. Refer to the table on page 9 ‘Technical specification’ for the weight of the
Command-Centre
TM.
Airflow
The ambient temperatures this unit should operate within are 5ºC - 35ºC. Proper air circulation must be
provided. The system will operate satisfactorily only if the recommended air gaps are provided. See section 2
,’Ventilation’ for correct installation to prevent overheating. The door buffers supplied must be fitted.
Altitude
Water boils at varying temperatures at different altitudes. The HydroTap
®
G4 adjusts for this during startup
calibration and will recalibrate itself on a regular basis.
Frost protection
If this appliance is located where the ambient air temperature could fall below 5ºC when the heater is not in
use, do not turn off the electrical power. This safeguard does not offer the same protection to the connecting
pipework and fittings.
Positioning
It is important to ensure that the Command-Centre
TM
is positioned in an accessible area close to the floor
level. It’s base must be mounted in a horizontal position with all inlets and outlets facing up. The tap must be
located above the Command-Centre
TM
see section 5 ‘Command-Centre
TM
installation’ for details.
Note
As with all refrigeration products the Command-Centre
TM
must not be turned on its side during
transport, installation or use.
