Page 22 of 28
802149UK Celsius residential - Installation instructions -Jan 2016 v2.03
Section 6
Commissioning
The HydroTap
®
G4 Celsius is now ready to be commissioned.
•
Turn the electrical power on at the mains and the Command-Centre
TM
ON / OFF switch.
•
Turn the gas and water on and check for any leaks.
•
Familiarise yourself with the operation of the HydroTap
®
G4 Celsius in preparation for use (see user
guide).
•
Follow the installation instructions below (and review section C of the user guide).
•
After commissioning, the system may be customised by selecting further options in section G -
Settings, of the user guide.
Note
At first commissioning, the system will select the filter flush screen automatically after CO
2
purge.
Have a bucket or similar container (not supplied) at the ready to hold a quantity of water that will be ejected
while the filter flush mode is in operation. Open the filter access door on the front of the HydroTap
®
G4
Celsius and the filter cartridge will be exposed. Located to the rear right hand side of the cartridge is a flush
line, approx 600mm long and the flush line stop cock. Place the free end of the flush line into the bucket or
container (not supplied).
Commissioning
• Press the [MENU] button for main menu.
• Press the [Install] button.
• Press the [Purge CO] button.
• In the next screen, press the [START]
button to commence the purging process.
• You will hear the CO
2
gas running through
the tap.
• Run for 10 seconds to fully purge the CO
2
.
• Press the [STOP] button to stop the purge.
• Press [Next] for filter flush screen.
6.1 - CO
2
Purge
(for chilled sparkling models)
6.2 - Filter flush
Note
At first commissioning, the system will select the CO
2
purge automatically, in this instance press the
[START] button to commence the purging process then follow the steps after [START] below.
Zip Chilled Sparkling
10.30 Wed 14, Nov 2013
Zip Chilled Sparkling
10.30 Wed 14, Nov 2013
