Page 52 TETHERED CONTROLLER MX32, RADIO CONTROLLER MX32FU
F
(
from
the
CV-
Prog
win-
dow
)
SERV PROG
– CV - Programming
(after pressing the
U- Key
)
After entering "CV-programming" (with the
U-Key
), the
first input line
is the first editable. If CV pro-
gramming is entered WITHOUT prior decoder identification, the message “… unidentified decoder” will
appear. The key sequences for programming are as follows:
… Program
a CV by
Typing a CV number
–
A-Key
– Enter a CV value –
A-Key
… Read-out
a CV by
Typing a CV number
–
A-Key
– (again)
A-Key
CV programming success (or failure)
report at the end of each line after completion with
the
A key
:
ACK
successful CV programming (acknowledged)
READ
CV value read out successfully
NACK
programmed without acknowledgement
NO-R
CV read-out failed
An automatic line feed
occurs after each programming or read-out step in order to immediately proceed
with the next CV. Use the
Scrolling wheel
to edit values or CV numbers of previously edited lines,
C-Key
to delete the highlighted number (CV number or value), then enter a new value in the field
followed again with the A-Key; the process of correcting a line is the same as entering to a new line
(see above).
The following actions can be taken at any time during CV programming:
F-Key
activates
the vehicle and switches to the
LOCO
mode (only when the address is known, i.e. if
the decoder was identified with the TP-Key or ad-
dress read-out with A+A, before starting the CV pro-
gramming).
E-Key
returns
to the programming menu screen
and pressing the E-Key again returns to the screen
the controller was in before entering
SERV PROG
,
which is usually the
LOCO
or
SWI
mode.
U-Key
opens an editing window for the CV current-
ly worked on, to turn individual bits ON/OFF, some im-
portant CV’s come with a description and a hexadeci-
mal representation.
.
Examples
U
(on
CV 28)
U
(in this
example
AFTER
identifi-
cation
with TP
or
A+A)
266
A,
45
A,
277
A,
100
A
5
A
U
(on
CV
112)
NOTE: In many cases, the individual bits
have no standardized meaning and can be
used differently by the decoder manufac-
turers. Therefore, full names of some CVs
are only available if the decoder was previ-
ously identified (
TP-Key
) as ZIMO decod-
er.
