Page 2 INSTRUCTION MANUAL CENTRAL COMMAND STATION MX10
Normal screen
BLUE
Voltages, currents, track 1 / 2, communication statistics, AOS
VOLT & AMP main settings
YELLOW
Output voltage, maximum current track 1, track 2
, B. 1 (
)
VOLT & AMP detailed settings
YELLOW
All possible configurations concerning voltage and current, such as: Turn-off
times, tolerance
2 sec
STOPP & OFF
RED
Broadcast Stop BCS, OFF track 1, track 2, overcurrent OVC (short circuit)
Button 3 (
)
BaseCab LOCO
GREEN
Set vehicle address, drive with rotary knob, activate functions per buttons
Button
2
MENU
GREY
Select menu points by scrolling and pressing the rotary knob
M,
,
DCC SERV PROG settings
YELLOW
CV programming and read-out on the programming track (track 2)
M,
,
MX10 Config
GREY
Various settings as language, radio channel, sniffer input, booster, etc.
Various information like software version, information statistics, date/clock, etc.
flash drive.
UPDATE & SOUND
GREY
Update decoder and load sound from the flash drive
Legend:
Rotary knob rotating fast
rotary knob scrolling
pressing rotary knob
button 1
M
button 2
button 3
Display (128 x 32, RGB backlight)
USB (Host) socket
Slot for the flash
drive.
Insert
UPDATE
& SOUND
Select files to update
the decoder or to
load sound,
also for MX10’s self-
update.
Rotary knob
Normal operation
BLUE
- protection against erroneous activation: Press and rotate shortly
NO effect
(Rotating fast)
.
operating state VOLT & AMP main settings
(screen
YELLOW
)
.
(Pressing long: 2 sec)
Broadcast Stop BCS and operating state STOPP & OFF (
screen
RED
)
(Press 1 sec)
cancel broadcast stop, back to normal operation (or to operating state active before)
SYSTEM STANDBY (track 1, 2 OFF, controller-supply OFF, display OFF, etc.)
(Pressing long: 4 sec)
.
Beyond normal operation (screen) -
scroll and
select,
adjust
driving
direction, ...
3 buttons
Normal operation, normal screen
BLUE
-
Button
1
(
)
operating sequences OPS, configurations and control
Button
2
(
MENU
)
Menu to select operating states
GREY
Button
3
(
)
operating state “BaseCab LOCO”
GREEN
STOPP & OFF (after pressing rotary knob 2 sec
or short circuit)
RED
Button
1
BCS, OFF, ON track 1 button
2
... track 2
BaseCab LOCO
GREEN
Buttons
1, 2, 3
(after selecting a group)
controlling functions
UPDATE & SOUND
BLUE (
GREEN
)
Button
1
Start decoder update
Button
2
Start sound loading
Button
3
(if not used differently)
back to normal screen
(
BLUE
)
ZIMO CAN and XNET sockets
CAN bus for a 6-pole connection
to ZIMO controllers and modules; addition-
ally on the 8-pole socket: sniffer inputs.
Note: Stationary equipment modules StEin are
NOT connected to this CAN socket, but to a sock-
et on the rear side of the MX10.
XNET socket for the connection to ROCO
Lokmouse and others; additionally on the 8-
pole socket: second ZIMO CAN bus and
second XNET bus (in reserve).
SUSI plug
Fast sound loading via SUSI
interface.
