Device Setup
5
Page 5
Note:
Make sure that the power switch on the device is set to "0".
Mains cable
connection
Connect the power cable to the appropriate socket on the device and
connect the cable to the mains.
Note:
The device may only be connected to power outlets with grounding
contact.
Handpiece
connection
Connect the handpiece to the socket on the rear of the SysCart.
Footswitch
connection
Connect the footswitch to the socket and place it on the floor.
Switch on the device Switch on the device with the main switch on the lower left front of the
monitor.
Filling the water
circuit
See Chapter 14
Switch off the device
The unit is switched off via the main switch (6). To disconnect the unit
completely (all-pole) from the mains supply, the power cord has to be
removed.
Attention
!
All cables must be protected from any mechanical damage.
Attention
!
After horizontal transport or assembly, the device must stand upright for
at least 30 minutes prior to being switched on. The compressor might
otherwise be damaged.
Note:
The user is responsible for the use of the device. The device may not be
modified without the consent of the manufacturer. The party combining
the device and thus operating a medical system is independently
responsible for combining the devices correctly.
Summary of Contents for Z Wave Q
Page 1: ...User Manual ZWaveQ USA...
Page 2: ......
Page 3: ...Illustrations Front of the device Fig 1 Encoder Handpiece...
