INSTALLATION AND OPERATING INSTRUCTIONS:
2-jaw parallel gripper, hybrid, HRC-04 series
31
Zimmer GmbH
●
Im Salmenkopf 5
●
77866 Rheinau, Germany
●
+49 7844 9138 0
●
+49 7844 9138 80
●
www.zimmer-group.com
DDOC00269 / d
EN / 3/31/2020
11. Maintenance
Maintenance-free operation of the gripper is guaranteed for up to
10 million cycles
.
The maintenance interval may shorten under the following circumstances:
• Dirty environment
•
Improper use and use that does not comply with the power specifications.
•
Ambient temperature of more than 60°C; lubricants harden faster!
• Operation with compressed air that does not comply with DIN ISO 8573-1 [4:4:4].
Even though the gripper is, as mentioned, maintenance-free, perform a regular visual inspection to check for any corros-
ion, damage or contamination.
We recommend using the Zimmer Customer Service for maintenance and the replacement of seals.
Dismantling and reassembling the gripper without authorization may result in complications, as special installation
equipment is required in some cases.
Zimmer GmbH shall not be liable in the event of unauthorized dismantling and reassembling of the gripper or in the
event of any malfunction or damage resulting from this.
12. Accessories/scope of delivery
INFORMATION: If any accessories not sold or authorized by Zimmer GmbH are used, the function of the
gripper cannot be guaranteed.
The accessories from Zimmer GmbH are specifically fitted for the individual grippers.
Please refer to our website for information on corresponding accessories.
13. Transportation/storage/preservation
►
The gripper must be transported and stored only in the original packaging.
►
If the gripper has already been installed on the superordinate machine unit, care must be taken during transport to
ensure that no unintentional movements can occur. Before commissioning the machine after transport, check all
power and communication connections as well as all mechanical connections.
►
If the product is stored for an extended period, the following points are to be observed:
Ö
Keep the storage location as dust-free and dry as possible.
Ö
Avoid temperature fluctuations/observe and adhere to the temperature range.
Ö
Avoid wind/drafts/water condensation formation.
Ö
Package the product.
Ö
During storage, it must be kept from direct sunlight.
►
Clean all components. There must be no soiling left on the components.
►
Visually inspect all of the components.
►
Remove all foreign objects.
►
Properly remove potential corrosion spots.
►
Close electrical connections using suitable covers.
14. Decommissioning and disposal
INFORMATION:
If the gripper reaches the end of its operational phase, the gripper can be completely disassembled and
disposed of. Disconnect the gripper from the power supply completely. The gripper can be disassem-
bled and properly disposed of according to material groups. When disposing of it, observe the locally
applicable environmental regulations and codes and regulations for disposal.
