System set-up
4
Page 8
Set-up
There is a handle (11) on the back of Cryo 7.
You can use this handle to push Cryo 7 and move it to its destination.
Assembly of the
treatment tube
Mount the treatment tube with the magnetic components at the air outlet
(note the orientation relative to the indentation) at the rear of the device (19).
The treatment tube is secured using the magnetic components on the air
outlet.
Assembly of the
spring arm
Insert the spring arm in the intended hole which is located at the top of the air
outlet (20).
The spring arm holds the treatment tube and assists the user by supporting
the weight of the treatment tube.
Assembly of the tube
in the spring arm
Place the treatment tube in the guide of the spring arm
Dismantling the
treatment tube
Remove the treatment tube from the guide of the spring arm.
Remove the spring arm from the air outlet. Hold the treatment tube on the
device end at the plastic sleeve. Tilt the tube towards the left or right by
pressing firmly with your thumbs and pull it out at an oblique angle.
Due to the strength of the magnets, a certain amount of resistance must be
overcome.
All application parts which can come into contact with the patient must be
cleaned before initial use and before the first patient contact in order to
remove residues from production and packaging. No part of the device may
be in the immediate vicinity of the patient since this is a contactless
application.
AC mains
connection
Guide the power cable under the handle.
Connect the power cable to the provided port on the device (17) and connect
the cable to the mains.