System set-up
4
Page 7
Important notes
After transport/assembly or repair, Cryo 7 must be placed in and kept in an
upright position for at least 30 minutes before being switched on. If Cryo 7 is
switched on before the 30 minutes have elapsed, the compressor can
become damaged.
The mains plug may be inserted only in a power outlet with a protective
contact.
Removal from the
packaging
Cryo 7 can be removed from the packaging by the user on site.
Cryo 7 is delivered in a box on a wooden pallet.
The device and accessories are housed in the box.
Open the box by lifting the lid.
To facilitate removing the device from the packaging, you can fold the lid of
the box into a ramp.
You can roll Cryo 7 off the pallet using the ramp.
Converting the lid
into a ramp
Follow the conversion instructions enclosed with the box or follow the
conversion instructions in our YouTube video. To do this, scan the QR code
(on the side of the lid of the Cryo 7 box) using your smartphone.
Remove the accessories box at the rear of Cryo 7.
Remove the white plastic protective inlay.
Lift the box upwards off the pallet.
Ensure that there is adequate space above the pallet and that there is
nothing above the box which could be damaged.
Remove accessories box 2.
Attach the ramp (converted lid) to the pallet.
Release the brakes on the castors of Cryo 7. Roll the device out slowly and
carefully.
It is important to support the device.
Risk of tipping!
Reassemble the box, following the steps in reverse order.
Keep the box.