BlackKite, Vehicle Tracking System User Manual
Rev. 1.4.0
Zilogic Systems
Page 18
1. Click
Vehicle Parameters
button on the
Configuration
menu.
2. Select the
Digital Input
checkbox under
Parameters Selection
to enable transmission of digital
input status.
4.4.2.1. Configuring through Commands
The command sequence is provided below:
1. Send
ADD MAINPACK DIN
, to add digital input information.
2. Send
SAVE
for the changes to take effect.
4.4.3. Digital Outputs
BlackKite-Fleet digital outputs are active and available when the device is connected to the vehicle
battery. User could connect and control electrical devices with the digital outputs using automotive
relays.
When enabled, BlackKite-Fleet, continuously monitors and sends the digital output status to the
server.
Refer Section 6.4, “Connecting a Relay” for connecting a relay to the digital output.
Let’s consider a scenario in which two relays are connected to digital output 1 and 2. The transmis-
sion of the digital output data to the server can be enabled either through the Configurator GUI
or through commands as shown below.
4.4.4. Configuration through GUI
1. Click
Vehicle Parameters
button on the
Configuration
menu.
2. Select the
Digital Output
checkbox under
Parameters Selection
to enable transmission of dig-
ital output status.
4.4.4.1. Configuring through Commands
The command sequence is provided below:
1. Send
ADD MAINPACK DOUT
, to add digital input information.
2. Send
SAVE
for the changes to take effect.
