Exhaust air fan Aero_aH 100 with integrated room and cellar dehumidification control
1019-1-0002
Handbuch 31.01.2021_JUSC_Aero_aH100|
20
7.
Insert the housing [1] into the wall
opening/wall sleeve and fasten it with two
screws. Do not insert the housing in a
strained or squeezed position. Use
properly dimensioned fastening material.
8.
Lay the cable from the outdoor climate
sensor [12] in the notches provided (I, II)
and plug it onto the electronics board [7]
[A].
7.4.
Electrical connection
DANGER
Danger to life from electric
shock
Switch off the mains fuse.
ATTENTION:
Risk of damage to
the device in the event of short
circuits.
Insulate the protective earth
conductor and unnecessary
wires.
1.
Only lay single wires in the unit. Remove
the sheath from the mains cable for a
length of 70 mm. Strip the insulation of
individual wires to 9 to 10 mm.
2.
Connect the mains cable to the spring
terminal [13] according to the wiring
diagram [14],
see also wiring diagram in chapter 13.
3.
Check position of cable grommet [9].
It must be well sealed.
7.5.
Final assembly
ATTENTION:
Danger of short circuits
and damage to the unit. Moisture
penetration from incorrectly placed
electronics cover.
Press the electronics cover tightly
against the housing so that it forms a
seal and lies flat all around. Do not
press the buttons [15] and [16].
Before fitting the electronics cover,
check the position of the sensor cable
from the outdoor climate sensor so
that it does not block the installation
of the indoor climate sensor.
1.
Insert the electronics cover [6] with the
three catches into the housing recesses I,
II and III until they click in place. At the
same time, press the electronics cover
firmly into the housing at the positions.
indicated by the arrows
.
