Zigmund & Shtain FI-64, Installation, Use And Maintenance Instructions

Page: 40 / 102

38
Maintenance and cleaning
ATTENTION
Disconnect the electric power supply before
performing any type of maintenance on the
product
• Do not clean the appliance using steam
cleaners.
• Do not use rough, abrasive materials or sharp
metal scrapers to clean the oven door, as they
can damage the surfaces and cause the glass
to break.
• Do not use acid products (like anti-scaling
agents) as they can damage the enamelled
parts.
• Turn off the heating elements, wait for the
internal parts of the oven to cool down before
touching or cleaning them. When cleaning with
a wet sponge or soft cloth, take all due care if
the surface is hot as it will produce steam and
you will risk scalding yourself. Moreover, some
detergents create noxious fumes on contact
with the heat.
The enamelled or stainless steel parts must
be treated with caution. Use water or specific
products, accurately drying with a soft cloth. In
case of heavy deposits in the enamelled parts,
use a sponge (non-abrasive) dampened with
warm water and vinegar. Residual foods and
dirt must be removed immediately. It will make
removing them easier if the internal parts of the
oven are cleaned while they are still warm.
ATTENTION
The symbols stamped on the appliance (e.g.
around the knobs) can be damaged if dirt
remains for an excessively long period on
them.
Dirt residue must be removed immediately but
use products specifically for steel as other overly
abrasive ones could cause the symbols to fade.
Regularly check the state of the rubber gasket
located around the oven opening. If gasket
damage is noted, contact the nearest technical
after-sales centre.
Removing/mounting the oven door
Before removing the oven door, check the type
of hinges installed on the door. There are two
possible models: standard and soft closing
hinges.
The removal procedure is different depending on
the type of hinge installed.
Standard hinges
Open the door completely and insert a metal rod
into both hinges (not supplied). This must have
diameter of approx. 3 mm and be inserted into
the hole indicated in the figure.
Fig.1
Grasp the door with both hands on the sides
down. Lift the door slightly and remove the hinges
from 2 locations. Pull the door toward you to
release the hinges from their seats. To re-insert
the door, operate in reverse order. With the oven
door fully opened, remove the two metal rod from
hinges. Close the oven door slowly and make sure
that it has been correctly inserted and aligned.