Zigmund & Shtain FI-64, Installation, Use And Maintenance Instructions

Page: 13 / 102

EN
BUILT-IN ELECTRIC OVENS
INSTALLATION, USE AND MAINTENANCE INSTRUCTIONS
11
Analogue cooking end programming clock
Allows a cooking end to be programmed
(maximum 3 hours) in the same mode as the PSC
by turning the small knob
always clockwise.
Adjusting the time: pull the knob lightly and turn it
clockwise until the clock is set at the current time.
Manual operation: Turn the knob clockwise until
the hand reaches the manual symbol.
ATTENTION
The oven cannot work if the programmer is
at O
ELECTRONIC R PROGRAMMER INSTRUCTIONS
(MODELS FI-64/74 MTR-WTR)
This timer displays the time and operation of
the oven.
By operating on the push knob it is possible: to
adjust the time, program the start and end time
of cooking, set the alarm.
Adjusting the time
To adjust the time, briefly press the knob 4 times
until the “CLOCK” icon flashes.
Therefore, increase or decrease the time in
steps of 1 minute, turn the knob clockwise or
anti-clockwise and the minutes hand moves by 1
minute clockwise or anti-clockwise.
After 10 seconds from the last adjustment, the
electronic timer automatically exits the time
adjustment mode.
Manual cooking
At rest, the timer allows manual cooking by
operating on the oven master switch (outside the
device).
After having supplied the mains power supply to
the timer, wait approx. 2 seconds before the relay
is energised.