ZIEHL-ABEGG ZAdyn4CA HY Series, Quick Start Manual

Page: 4 / 28

1 General notes
Compliance with the following instructions is mandatory to ensure the functionality and safety of the
product. If the following instructions given especially but not limited for general safety, transport,
storage, mounting, operating conditions, start-up, maintenance, repair, cleaning and disposal / recy-
cling are not observed, the product may not operate safely and may cause a hazard to the life and
limb of users and third parties.
Deviations from the following requirements may therefore lead both to the loss of the statutory material
defect liability rights and to the liability of the buyer for the product that has become unsafe due to the
deviation from the speci
fi cations.
1.1 Validity
This instruction manual applies to:
Frequency inverter from the series: ZAdyn4CA HY
from software version 4.53
1.2 Structure of the operating instructions
These operating instructions are intended to be a short guide with additional information. They
are only valid in conjunction with the following operating instructions:
•
R-TBA12_01 (ZAdyn4C)
Before installation and start-up, read this manual carefully to ensure correct use!
1.3 Exclusion of liability
Concurrence between the contents of these operating instructions and the described hardware and
software in the device has been examined.
It is still possible that non-compliances exist; no guarantee is assumed for complete conformity. The
contents of this manual are put through periodic reviews. Necessary modi
fi cations are incorporated
into the next version.
ZIEHL-ABEGG SE is not liable for damage due to misuse, incorrect use, improper use or as a
consequence of unauthorized repairs or modi
fi cations.
2 Safety instructions
The
Safety informations,described in chapter 2 of theoperating instructions R-TBA12_01 has to be
followed!
3 Product overview
3.1 Application
The ZAdyn4CA HY is a fi eld-orientated Frequency inverter for speed control of three-phase asynchro-
nous motors in hydraulic lift systems.
The ZAdyn4CA HY is designed for the modernisation of existing hydraulic systems.
The ZAdyn4CA HY is equipped with a microprocessor control. The use of IGBT modules and pulse
width modulation with variable switching frequency enables low-noise operation of the motor. The
user interface, interfaces and software adapted specially to lift technology enable easy installation and
start-up of the machine.
3.2 Functional description
The device was designed to modernise hydraulic systems. The soft starter is replaced by the
ZAdyn4CA HY. Thus, the ZAdyn4CA HY is only used for lifting. Lowering is still done by means of the
lowering valve of the valve block. The ZAdyn4CA HY is connected to the elevator control system via
DCP4. For this purpose, the elevator control system must possess a shaft copying encoder. For lifting
operations, the elevator control system gives the ZAdyn4CA HY a travel command with target position
via DCP4 and at the same time completely opens all open valves on the valve block up to the end of
travel. The travel curve is completely controlled via the ZAdyn4CA HY. A brake resistor is not
necessary.
Quick Start Guide ZAdyn4CA HY General notes
R-TBA16_01-GB 1845 Index 003 Part.-No. 00163456-GB
4/28