Ziegler & Brown ZG3GK, Operating Instructions Manual

Page: 12 / 36

Lighting your Barbeque
Before using the barbeque please ensure that you have fully read and understood the
IMPORTANT HEALTH & SAFETY INFORMATION section of this manual.
STARTING THE BARBEQUE:
Lighting the barbeque is easy, but must be done with due care.
•
Make sure that the gas is turned on at the cylinder, or supply valve to the
barbeque.
•
Ensure that the hood is fully open.
•
Ensure that all the controls are in the
OFF
position prior to initiating the start up
process.
•
Make sure there are no obstructions of airflow to the gas unit. Spiders and
insects can nest within and clog the burner/venture tube at the orifice. A clogged
burner tube can lead to a fire beneath the appliance.
Flame Thrower Ignition :
This ignition system works by throwing a flame to the side of the
burner to light it. Push any control in and turn anticlockwise to the HIGH position. Hold the
control knob in until that burner ignites. You may need to push and turn the knob a few times
before ignition, as it may take around 5 seconds of flow for the gas to reach the burner.
Manual Ignition :
You can light your barbeque manually by using the match holder provided
to hold a lighted match next to one of the burners, then turning that burner control knob to
HIGH . You can access the burner through the cooking grills.
If the burner doesn’t light first go, return the control knob to the
OFF
position and try a
couple more times. If the burner still does not light, wait a few minutes to allow the gas
to disperse before trying again. If satisfactory operation cannot be achieved check the
troubleshooting guide on page 24. Otherwise, consult your retailer before proceeding.
Note carefully: Failure to follow the lighting procedures correctly can lead to a hazardous
condition.
12