Zhermack elite mix, User Manual

Page: 26 / 36

124 of 264
MAINTENANCE AND USE MANUAL
elite mix
EN
CHAPTER 8: MAINTENANCE
8.1
CLEANING
The machine exterior can normally be kept clean just by wiping it with a dry cloth. If necessary,
wet the cloth just a little water or use a non-degreasing detergent.
The operator must ensure that the machine is kept clean and free from any foreign bodies such
as dirt, water, non-conducting liquids etc.
The machine must be cleaned at the end of every work session to remove all residues.
Cleaning must be done with the machine at standstill and positioned in a stable manner.
Never use inflammable, corrosive, alkaline or toxic liquids when cleaning the
machine.
Do not use alcohol or solvents to clean mixing unit components.
Eye goggles and a face mask must be worn when using compressed air for
cleaning purposes. Do not allow any persons near the machine as they could
be hit by flying dust.
Before cleaning the machine exterior always turn the main switch to OFF. It is
strictly forbidden to clean the machine while it is connected to the mains power
supply.
8.1.1 Cleaning the mixing unit
Once mixing is over it is necessary to clean the components (lid with spatula and cup).
Wash them with plenty of water.
8.1.2 Changing the intake filter
Apply Vaseline to the rubber seals on the lid every now and then.
This will make the seals last longer and also ensure optimal vacuum
performance.
Figure
16
Fig. 16 : The pre-filter is located on the inner side of
the mixer unit support; change it with the aid of the
supplied key.
Do not use the machine without the
filter.