172 of 228
MAINTENANCE AND USE MANUAL
furnace DM
EN
The programming mode for the
DM 4R
oven is exactly the same as on the
DM
oven.
7.15
PROGRAMMING MODE FOR DM 4R OVENS
P
O
N
Figure
7
Fig. 7 :
Make sure that the switch (
P
) to the right of
the panel is turned downwards to position 0. This
ensures that when the oven goes to Phase 2, the pan
(
N
) starts turning and the red LED (
O
) comes on.
Figure
8
Fig. 8 :
When the door is opened the pan stops. To
bring it into the desired position act on the
ENTER
k e y
.
7.16
RESIDUAL RISK
Residual risk is:
• a danger that cannot be completely eliminated through design and application of safety
devices.
• a potential danger which cannot be highlighted.
DM
series ovens reach very high temperatures and thus allow specific odontotechny materials
to be fired; the residual risks thus consist of:
• accidental contact (and/or caused by a safety system fault) with the materials or the equipment
itself, during and after the melting phase (risk of serious burns to limbs).
• inhalation of fumes or combustion gas caused by backflow from an incorrectly positioned
aspiration tube.
• work carried out on the equipment interior by unauthorised personnel.
