167 of 228
MAINTENANCE AND USE MANUAL
furnace DM
EN
DM series ovens provide users with cycles having up to 8 work phases. This is made possible by
uniting programs 8 and 9.
Proceed as follows:
A.
With the oven
OFF
press key 9.
• the display (
11
) shows: “8 9 normal functions” or “8 9 combined 8-phase mode”.
If the display (
11
) shows 8 9, press the
PROG
key or key 9 again.
• 8 – 9. appears on the display (
11
).
• press
ENTER
to save.
B.
Now set program 8.
After setting the holding time in phase 5 of program 8 the oven automatically goes to phase
2 of program 9.
C.
Now set the data for program 9.
D.
After setting the fan shutdown temperature and confirming the data by pressing
ENTER
,
the duration of the combined program appears on the display (
11
).
E.
Press
ENTER
again:
• OFF appears on display (
11
)
• 9 appears on display (
14
)
• 1 appears on display (
15
).
F.
Now recall program 8 by proceeding as follows:
• press the
PROG. SELECT
. key (
12
).
• “
P
” appears on display (
14
).
• press key “8” on the numerical keypad.
If you wish to return program 8 to its standard 4-phase operating mode, proceed as follows:
• with the oven
OFF
, press key 9.
• 8 - 9 appears on the display (
11
).
• press key 9 again or press
PROG
.
• 8 9 appears on the display (
11
).
• press
ENTER
.
7.7
CREATING AN 8-PHASE WORK CYCLE
To recall the desired program proceed as follows:
A.
With the oven
OFF
press
PROG. SELECT
(
12
). The letter “
P
” appears on the display (
14
).
B.
Press the number (0 - 9) relevant to the program you wish to enter.
7.8
CHOOSING A PROGRAM
