170 of 228
MAINTENANCE AND USE MANUAL
furnace DM
EN
If for some reason the operator decides to change the data once the program has already been
launched, he/she must proceed as follows:
A.
Press
START-STOP
(
20
): the word
OFF
appears on the display (
11
).
B.
Press
PROG.
(
19
): the legend “
Pro
” appears on the display (
11
).
C.
Press
ENTER
and the following occurs on the control panel:
• the green horizontal segment of the recalled phase comes on.
• the first of the three parameters (i.e. temperature) (
11
) appears.
• the number of the recalled phase appears on the display (
15
).
• the green
PROG. LED
(
27
) flashes.
D.
Change/cancel one or more of the phase data items.
E.
Save all changes by pressing
ENTER
.
F.
Press
START/STOP
(
20
) to return to the display (
11
):
F
appears.
Key in the number of the phase from which you wish to begin.
G.
Press
START/STOP
(
20
).
7.11
CORRECTING DATA ON A PROGRAM THAT IS RUNNING
If an undesired program is launched by mistake, proceed as follows:
A.
Press
START-STOP
(
20
):
OFF
reappears on the display (
11
).
B.
Press
SELECT./PROG.
(
12
): “
P
” appears on the display (
14
).
C.
Press the correct program key: the corresponding number appears on the display (
14
).
D.
Set the oven start time as described in Chapter 4 “Programming Oven Start Time”.
7.12
CHANGING THE PROGRAM IN PROGRESS
Several checks can be run while the oven is working:
A.
During phase 1 / Delayed start on
1.
Pressing
TEMP.
(
17
) on the display (
11
) causes the current in-chamber temperature to
appear.
• after a few seconds the display returns to its previous state.
7.13
CHECKS DURING WORK
