090317-NUT-SPLIT-MULTISPLIT-EN
13/24
EN
Note:
-To limit the effect of the dehumidification mode on the room temperature, the product alternates the cooling
(COOL) mode with the fan only (FAN) mode.
•
Selecting the fan speed
By pressing the FAN SPEED button on the remote control, the fan speed of the indoor unit can be selected in the
following order: automatic speed -> LOW (low speed) -> MED (medium speed) -> HIGH (high speed) -> back to
automatic speed-> Etc.
•
Programming (TIMER)
Automatic start programming function
When the product is stopped, this function enables the user to programme the time at which the product will start
up.
-With the appliance stopped, and outside the receiver range, press the ON/OFF button twice to delete all
previous programmes.
-Press the TIMER ON button once
-TIMER ON appears on the remote control; the letter "h" appears next to the value 0.0 which indicates
the countdown in hours and minutes before the product will start operating.
-Then press the TIMER ON button several times, the length of time before starting will increase in
increments of 30 mins until 10h, then in increments of 1hour until 24h.
- A half-second after depressing the TIMER ON button (once the desired length of time before starting
has been set) the remote control sends the start programme command to the product (for remote
controls R11HG/E and R05/BGE, press OK to validate the timer setting)..
-The TIMER ON message and the operating indicator remain displayed on the remote control indicating
that a start programme is active, the set temperature is once again displayed after a few seconds and the
"TIMER" programming indicator of the indoor unit display panel is shown.
Automatic stop programming function
When the product is operating, this function enables the user to programme the time at which the product will stop
operating.
-With the appliance operating, and outside the receiver range, press the ON/OFF button twice to delete
all previous programmes.
- Press the TIMER OFF button once.
-TIMER OFF appears on the remote control; the letter "h" appears next to the value 0.0 which indicates
the countdown in hours and minutes before the product will stop operating.
-Then press the TIMER OFF button several times, the length of time before stopping will increase in
increments of 30 mins until 10h, then in increments of 1hour until 24h.
- A half-second after depressing the TIMER OFF button (once the desired length of time before starting
has been set) the remote control sends the start programme command to the product (for remote
controls R11HG/E and R05/BGE, press OK to validate the timer setting).
-The TIMER OFF message and the operating indicator remain displayed on the remote control indicating
that a stop programme is active, the set temperature is once again displayed after a few seconds and
the "TIMER" programming indicator of the indoor unit display panel is shown.
Automatic start and stop programming function
When the product is stopped, this function enables the user to programme the time at which the product will start
up and the time at which the programme will stop again.
-Carry out the automatic start and automatic stop programming stages successively.
-The TIMER OFF message and the operating indicator remain displayed on the remote control indicating
that a programme (start + stop) is active, the set temperature is once again displayed after a few
seconds and the "TIMER" programming indicator of the indoor unit display panel is shown.
Or
When the product is operating, this function enables the user to programme the time at which the product will stop
and the time at which the programme will start up again.
-Carry out the automatic stop and automatic start programming stages successively.
-At the end of these stages, the TIMER OFF message and the operating indicator remain displayed on
the remote control indicating that a programme (stop + start) is active, the set temperature is once again
displayed after a few seconds and the "TIMER" programming indicator on the indoor unit display panel is
shown.
Note:
The TIMER function is only active once: once the programming function has been carried out, the product returns to the
previously programmed operating mode and the "TIMER" indicator on the indoor unit display panel disappears.
