Zetor Proxima CL 100, Operator'S Manual

Page: 175 / 210

Front PTO
Addition of the liquid for control of the clutch
The inspection and filling plug of oil (1) is situated on the
front side of the front PTO case.
Note: The front PTO with the standard turning direction is
equipped with a hollow bolt of the oil cooler hose instead
of the inspection and filling plug. Perform the check after
removing the hollow bolt.
After unscrewing of the inspection plug the oil
level must reach the bottom edge of the inspection
opening. During the oil replacement the oil cleaning
strainer (2) must be cleaned. The cleaning strainer is
accessible after the disassembly of the locking ring
and removal of the cap.
PCLPN077
1 - lubricating nipple of the kingpin
2 - sliding bearings (2 pieces) of the front driving axle
3 - drain opening of the final drive hous-ing oil
4 - filling and inspection opening of final drive housing oil
(after removing of the inspection screw the oil level must
reach the bottom edge of the inspection opening)
PCLPN078
Inspection, filling and draining oil is done by a one hole
after turning reducer according to figure.
1. amount of oil inspection - hole in the horizontal axis of
a reducer (after unscrewing control screw the level of oil
must reach the brim of checking hole)
2. filling oil - hole at the top
3. draining hole - hole at the bottom
PCLPN079
The reservoir is located on the left side of the tractor in
front of the cabin and is accessible when the front engine
bonnet is open.
Maintain the liquid level within the range from 3/4 of the
reservoir content (max. height) to 1/2 of the reservoir
content (minimum level height).
Strictly maintain the cleanness when handling
the liquid. Check the level height daily prior to the
drive.
PCLPN080
MAINTENANCE INSTRUCTIONS
174