Written by:.JBJ
Checked by: RP
Document Number: Premier MX User 1.doc
Page 11 of 19
14/12/06
•
To select the sounders:
o
Use the Select
↑
button to move the pulsed cursor indication up
through the fault LEDs until it pulses the Sounder Fault/Disabled and
Sounder Test LEDs. [The Select
↓
button moves the cursor down].
•
To activate the sounder test:
o
Press the Test button to start the sounder test.
o
The Sounder Test LED will change to the “On-flash” indication while
the cursor is on it, changing to steady if the cursor is moved.
o
The general Test LED will light.
o
The sounders will operate for 2 seconds every 15 seconds until the test
mode is switched off.
•
To terminate the sounder test:
o
Press the Test button again or press the Enable button to clear the test
condition enabling normal operation of sounders.
o
The sounders will silence.
o
The Sounder Test LED will change to the “Off-flash” indication while
the cursor is on it, changing to off if the cursor is moved on.
o
The general Test LED will be cleared if no other circuits are in the test
condition.
•
To quit test selection mode:
o
To exit the Select Mode, press the Select On/Off button.
o
The Select On LED will clear.
o
The cursor indication will clear.
o
Set the Access Controls Keyswitch back to position “0” to lock the
controls.
4.8.
To Enable/Disable Delay Mode
•
To access delay mode selection:
o
Turn the Access Controls Keyswitch on the panel door to position “1”.
•
To enable the delay:
o
Press the Delay On/Off/Override button once to enable the Delay
Mode.
o
The Delay On/Off LED will light.
o
The disable switch LED will light.
o
The fault/disabled LED for each delayed output will light.
•
To display the outputs configured to be delayed:
o
With the panel in the quiescent condition select the Access Controls
Keyswitch to position “1”.
o
Press and hold the Disablement button.
o
The fault/disabled LED on each output set to the delay mode will
illuminate.
o
The indications will clear when the Disablement button is released.
•
To disable the delay:
o
With the Delay On, press the Delay On/Off/Override button once to
disable the Delay Mode.
o
The Delay On/Off LED will clear.
o
The disable switch LED will clear.
o
The fault/disabled LED for each delayed output will clear.