BNP
®
6012 and 7212 SUCTION BLAST CABINETS
Page 30
© 2019 CLEMCO INDUSTRIES CORP.
www.clemcoindustries.com
Manual No. 27723, Rev. B 04/19
9.0
ACCESSORIES AND REPLACEMENT PARTS
9.1
Optional Accessories
Turntables and Turntables with Tracks
WARNING
Turntable capacities are based on concentric
loading. Use solid fixturing to hold heavy parts
in place. Do not remove lift equipment until the
part is adequately supported to prevent
movement. Moving or rotating heavy,
unsupported or off-centered parts may cause
them to shift or topple, and cause severe injury.
Fixed-Base Turntable with Bearing, 500 lb
Capacity ‒ Figure 32
Item Description
Stock No.
(-)
30" diameter turntable assembly ............... 14138
(-)
40" diameter turntable assembly ............... 24042
(-)
48" diameter turntable assembly ............... 13845
1.
Turntable, replacement
30" diameter, 500 lb. capacity ................ 21390
40" diameter, 500 lb. capacity ................ 23879
48" diameter, 500 lb. capacity ................ 21400
2.
Bearing, 1-1/2" bore (48" table requires 2) .. 11517
3.
Protector, bearing ...................................... 13479
4.
Bolt, 1/2-NC
2” long for 30" and 40" turntable ............ 03456
2-1/2” long for 48" turntable ................... 03457
5.
Lock-washer, 1/2" ...................................... 03516
6.
Nut, 1/2-NC hex ......................................... 03511
Figure 32
Turntable with Workcar and Track
2000 lb. capacity turntable mounted on workcar with
9 ft. (nominal) track extension
30" diameter for BNP 6012 ............................... 25550
48" diameter for BNP 6012 ............................... 27055
48" diameter for BNP 7212 ............................... 25555
Turntable with Workcar, 500 lb – 2000 lb Capacity
Figure 33
Item
Description
Stock No.
1.
Turntable, replacement
30" diameter 500 lb/2000 lb capacity ...... 21390
48" diameter 500 lb/2000 lb capacity ...... 21400
2.
Bearing, 1-1/2" bore, 1 req’d for 30” table
2 required with 48" table ......................... 11517
3.
Protector, bearing ..................................... 13479
4.
Wheel, 6" V groove ................................... 12220
5.
Bolt, 1/2" shoulder ..................................... 13477
6.
Washer, 1/2" flat ......................................... 03515
7.
Nut, 3/8 lock .............................................. 03312
8.
Bolt, 1/2-NC
2" long for 30" turntable ......................... 03456
2-1/2” long for 48" turntable ................... 03457
9.
Washer, 1/2" lock ...................................... 03516
10.
Nut, 1/2-NC hex ........................................ 03511
11.
Pin, quick release ...................................... 25540
Figure 33
* Lower bearing not used
with 30-inch turntable.
* Lower bearing used
only on 48" turntable.
1
3
2
5
6
4
*2
1
2
3
10
9
11
5
6
7
8
4
*2
