Capture the skies.
™
17_
When the Atlas battery is running low, the remote will issue a fast
series of beeps, signalling that the battery needs to be recharged.
PLEASE NOTE:
Do not ignore low power warnings as this may result
in unplanned landings.
4.1.7 MOTOR LOCK DOWN
When the rotor-blades are stopped by an obstacle the motors will go
into protective lock down.
To unlock the motors make sure the
rotor-blades are clear from debris
and put the Atlas back on the
ground. Once you are ready to fly
again pull the left thumb stick back
and the motors will release.
4.1.8 TRIMMING
Trimming is used to balance out
your drone if it is drifting when
flying.
To adjust the trimming please follow the steps below.
1.
Make sure that the Remote Control and Atlas are switched on and
correctly paired.
2.
Hold the Trimmer button on the rear of the Remote Control.
3.
While still holding the Trimmer button use the right thumb stick to
counter the direction that your Atlas is drifting.
4.
As you are adjusting the trimming the beep tone will go lower the
more that you trim in any directing.
PLEASE NOTE:
If Trimming is not fixing the drones drifting, you
may need to re calibrate your drone by turning off the drone and
the controller and restarting the instructions in the
Getting Started
section of this manual.
5. APP NAVIGATION
Once you have connected your Smart-phone to the Atlas via WiFi and
launched the
Zero-X Atlas App
, you will be able to access the App’s Control
screen. This screen has all of the control options and settings, as well as
access to the on screen control system.
If you want to only use your smart phone to control the Atlas drone, use
