Zero Motorcycles MX 2012, Owner'S Manual

Page: 67 / 142

4-18
XU only (if equipped)
1. Ensure that the key switch is in the OFF position.
2. Remove the quick charge connector protective
cover. This is located under the seat on the
right side of the motorcycle.
Note: AVOID connecting the Zero charger and another
device to a single 120 V AC 15A/20A circuit, as it may
become overloaded. Zero chargers draw as much as
10 amps from the 120 V AC circuit when charging.
4. Quick charging to 100% from a fully discharged
power pack takes about 2 hours of quick
charging.
5. When the power pack is fully charged, disconnect
the chargers.
6. Install the power pack into the motorcycle. See
Power Pack Swapping on page 4-8.
3. Connect the stand-alone charger to this connector.
4. Plug the supplied power cord (A) into the
integrated charger connector.
A