ZT MK2
Connection of controller and warning lights
35
www.zepro.com
6.2
Foot controller / Warning lights
If the tail lift is equipped with warning lights and/or foot controller, their cabling must be routed and connect-
ed according to the following description.
1. Connect the supplied cable to the connector on the foot controller/warning lights cable.
2. Run the cable and install with cable ties according to Picture 50.
3.
Connect the control device cables to ctrl 3 on the control card. See section
6.3.
4. Connect
the warning light cable to WL1 on the relay card. See section
6.3.
Route the cable between the platform and the 1st boom’s pipe, so it is well protected when the platform
hits the ground.
Leave enough "slack" to the first cable tie so the cable is not at risk of being damaged when the lift is
operated.
NOTE!
Picture 49. Warning lights and foot controller
Picture 50. Installing cabling
