ZT MK2
24
Installation
www.zepro.com
A
C
Max 10º
m
WARNING!
To ensure lift safety and CE compliance, adjust the
downward tilt angle to no more than 10º.
6. Run the lift up, so the platform reaches the vehi-
cle floor. Loosen the cylinder boots.
7.
On the tilt cylinder fitted to the platform, loosen
the lock screw (A). Screw the end stop all the
way back (B) towards the platform. See
Picture
32.
8. Tilt the platform down to max. 10º below the
horizontal. See
Picture 31.
9. Adjust the end stop all the way to the top of the
cylinder (C). Picture 32.
10. Fix the setting with the lock screw (A).
See
Picture 32.
Tightening torque: 3-5 Nm
11. Loosen the lock screw (A) on the other tilt cylinder.
12. Turn the adjusting collar so the tilt cylinder aligns
with the attachment on the platform and then fix
the setting with the lock screw (A).
13. Fit the other tilting cylinder to the platform’s
attachment. Use the enclosed shaft and screw.
Tighten the screw.
Tightening torque: 80 Nm
NOTE!
Make sure the cylinder is installed with the grease
nipple facing up.
14. Fit the tilt cylinder boots.
15.
Fit the support wheel on the shaft. Secure with
associated split pin.
16. Test all functions.
B
Picture 31. The downward tilt angle
must be adjusted to max. 10°
Picture 32. End stop with lock screw
Picture 33. Fit the tilt cylinder to the platform
